22/11/18
Specifications for safe operation of bottle blowing machines
1. Before the start of each shift, the moving parts must be lubricated once. (robots, robot rails, mold opening and closing rails) 2. The swing arm can be added every (3-4) days. The large and small chains of the heater can be used once a month.
1. Before the start of each shift, the moving parts must be lubricated once. (robots, robot rails, mold opening and closing rails)
2. The swing arm can be added every (3-4) days. The large and small chains of the heater can be used once a month. Frequently check whether the reducer of the main engine and the reducer of the heater are short of oil. Main bearings can be added every (2-3) months.
3. Before leaving the factory, check whether the moving parts are firm, whether the screws are loose or loose, especially in places with strong impact, and whether the belt transmission part is abnormal.
4. Check whether the high-pressure air source, low-pressure air source, power supply, and water supply are normal.
5. Check whether the emergency stop switch, safety switch and protection device detection switch are normal.
6. Check whether the feeding and falling parts of the heating head are working normally. If the blank pressing plate is not in place, the nut of the blank holding device can be adjusted.
7. Check whether the lamp tube is damaged or broken. Replace it in time.
8. Check whether the pneumatic components are leaking and sensitive.
9. Check whether the triplet is abnormally leaking, blocked, and whether the water storage capacity of the cup is too full.
10. When the solenoid valve of the blow molding machine is abnormal, it should be cleaned in time (blowing once every 3.5 million bottles).
11. Blowing molds must be cleaned and polished regularly.
12. When the high and low pressure air supply switch is turned on, you must move slowly to prevent dust from blowing into the solenoid valve because the air supply flow rate is too fast. At the same time, open the exhaust valve for 30 seconds to ensure that the air is clean.
RELEVANT
23/02/10
Precautions for operation of semi automatic blow molding machine 4cavity products
What should be paid attention to when operating semi automatic blow molding machine 4cavity products? 1. Open the cooling water valve before heating the machine to start production, and observe whether the water channel is unobstructed.
VIEW ALL
22/07/29
The future of blow molding machines will be brighter
The sales volume of blow molding machines in recent years has been better than before. At present, my country's blow molding machine manufacturers have developed their own core systems for blow molding machines, while the high-end market is just the opposite. one part.
VIEW ALL
22/07/29
What are the factors affecting the process quality of the mineral water blow molding machine?
The factors that affect the quality of the bottle blowing machine of the mineral water blow molding machine include: preform and its heating, pre-blowing (position, excitation and flow), stretching rod, pressure blowing (pressure and excitation position), and molds, etc.
VIEW ALL
It’s the simplest way to know everything.
contact
Our team are on hand 24 hours and 7days per week to answer any questions and inquiry that you may have
Copyright©2022 Taizhou Huangyan Shengjie Machine co.,Ltd All Rights Reserved